Formation of long range ordered arrangement of quantum dots with the help of lateral centripetal flow

A simple “chimney” method was used to eliminate the voids in an arrangement of quantum dots sized 2 nm on a solid substrate, which resulted in a large well ordered superlattice of area in the order more than 1 μm². Based on the principle of speeding up the interparticle interaction of nanoparticles to overcome the particle-substrate one, a lateral centripetal force originated from a glass tube acting as a chimney in a simple evaporation device is imposed. This method allows the packing process to be controlled in a mechanical force field, that is, with the same nanogold dispersion different patterns on a substrate—from separate dots to an ordered compact monolayer or even a multilayer structure—could be easily obtained.     

巯基丁二胺铜单层修饰金电极上HIV-p24抗原的电化学免疫检测

制备了用巯基丁二胺铜(CuL)修饰的金电极并用作HIV-p24抗原蛋白(简称p24)免疫检测的化学传感器。CuL通过单层自组装固定在金电极表面,其覆盖率为1.02×10-11mol.cm-2,在含有1.0 mmol.L-1过氧化氢并在pH 6.2的磷酸盐缓冲溶液中,制备的校正曲线的线性范围为0.5-150μg.L-1p24对相应的伏安响应,方法的检出限为0.2μg.L-1。在10μg.L-1p24浓度水平作精密度试验,得RSD值为3.5%,于试样中分别加入5,15,20及30μg.L-1p24进行回收率试验,所得结果在98%-102%之间。此方法毋需另加电子传递媒介体。应用此方法于临床血清分析,所得结果与放射性免疫法的结果一致,且所得RSD值均小于0.3%。     

金－钼酸盐－耐尔蓝缔合显色反应的研究

在聚乙烯醇存在下，金与钼酸盐形成络阴离子，继而与耐尔蓝形成离子缔合物，其最大吸收位于５９５ｎｍ，表现摩尔吸光系数ε值为２．７１×１０￣５Ｌ．ｍｏｌ￣（－１）．ｃｍ￣（－１），线性范围０～１６μｇ／２５ｍＬＡｕ，大多数离子不干扰。用于岩矿和冶金产品中金的测定，结果满意。     

Golden crowns: cation binding by macrocyclic gold(I) crown ether derivatives

The polyether bis(alkynes) α,ω-bis(O-propargyl)triethylene glycol and α,ω-bis(O-4-propargyloxyphenoxy)triethylene glycol reacted with [AuCl(SMe₂)] in the presence of base to form the corresponding oligomeric gold(I) acetylide complexes (AuCCCH₂O(CH₂CH₂O)₃CH₂CCAu)_n and (AuCCCH₂OC₆H₄O(CH₂CH₂O)₃C₆H₄OCH₂CCAu)_n. These digold(I) diacetylide complexes reacted with diphosphine ligands to give macrocyclic digold(I) complexes of the type [Au₂(μ-CC)(μ-PP)], where CC is the diacetylide and PP is a diphosphine ligand. These digold(I) complexes bind the cations Li⁺, Na⁺, K⁺ and Cs⁺, as studied by electrospray mass spectrometry.     

仲碳伯胺萃淋树脂吸萃金的性能及机理

研究了仲碳伯胺（Ｎ１９２３）萃淋树脂吸萃金的机理，溶液酸效应、吸附等温线、吸附速率、盐析剂效应及柱操作条件的影响等，将该树脂用于矿样中金含量的测定，结果与７１７＾＃离子交换树脂吸附法一致，取得了较好的结果。     

Gold nanoparticle-enhanced surface plasmon resonance measurement with a highly sensitive quantification for human tissue inhibitor of metalloproteinases-2

Two different methods for the quantification of human tissue inhibitor of metalloproteinases-2 (TIMP-2) were developed using surface plasmon resonance (SPR) and gold nanoparticles for signal enhancement. The first method, a competitive assay, used TIMP-2 immobilized to the sensor surface and the inactive form of matrix metalloproteinase-2 (proMMP-2) (EC 3.4.24.24) adsorbed to gold nanoparticles. The sensor signals resulting from the interaction of MMP-2-gold nanoparticles with immobilized TIMP-2 were inversely proportional to the amounts of TIMP-2 of the sample. The measuring range for TIMP-2 was about 15–180 pM. The second method, a one-step sandwich assay, used proMMP-2 immobilized to the sensor surface and an anti-TIMP-2 monoclonal antibody coupled to gold nanoparticles. The lower detection limit of this assay format was 0.5 pM of TIMP-2. The binding signals were highly reproducible up to 100 pM of the inhibitor. The improvements obtained in TIMP-2 quantification over already existing tests could contribute to a better understanding and diagnosis of diseases like cancer.     

Temporal evolution of Raman intensities on surface-enhanced Raman scattering active copper and gold electrodes at negative potentials

The effect of a roughening procedure on surface-enhanced Raman scattering (SERS) intensity of pyridine at copper and gold electrodes subjected to negative potential has been investigated. Among four procedures tested for a copper electrode the one consisting of electrochemical activation in a solution of LiCl and CuCl₂ resulted in the most stable and effective surface. It was proved that the presence of pyridine during the pretreatment procedure caused a very fast, irreversible decay of SERS intensity for both copper and gold electrodes. Quite stable, at least at room temperatures, gold surfaces were obtained by oxidation-reduction cycles activation in KCl solution.     

Anwendung der Streustrahl-Methode zur Bestimmung der Elemente in Mineral?lprodukten mit Hilfe der R?ntgenfluorescenz-Spektral-Analyse am Beispiel der Bleibestimmung in Ottokraftstoffen

Zusammenfassung In einem relativ einfach durchzuführenden Verbundverfahren wird Selen im Sauerstoff-strom innerhalb 15 min bei 1100–1150°C quantitativ aus den Metall- bzw. Metalloxidschmelzen verdampft und in einer mit flüssigem Stickstoff gekühlten Vorlage aufgefangen. Das aus der Vorlage mit einer definierten Menge verdünnter HNO₃ in Gegenwart von Ni-Nitrat gelöste Selen läßt sich direkt durch AAS mit dem Graphitofen (FAAS) äußerst nachweisstark und zuverlässig bestimmen. Die Nachweisgrenze (elektrodenlose Entladungslampe) liegt bei 3×10^–11 g Se. Der Verfahrensverbund erlaubt mit Probenmengen 10 g in Ag und Au Se-Gehalte 0,05 ppb,inCu 0,1 ppb,in Bi 0,2 ppb und in Pb 10 ppb zu erfassen. Für draht-, stab- und spanförmige Proben erhält man für Se-Gehalte von 2–0,002 ppm Variationskoeffizienten zwischen 3 und 6%. Die Vollständigkeit der Se-Verdampfung aus den Matrices Cu, Ag, Au und Bi wurde ebenso wie die Richtigkeit des Gesamtverfahrens durch systematische Untersuchungen belegt.

---

Determination of se by furnace atomic absorption spectrometry (FAAS) in the ppb-range in Cu, Cu alloys, Ag, Au, Pb and Bi after volatilization in an oxygen stream

Summary Selenium is evaporated in a multi-stage procedure within 15 min from metals or metal oxides fused at temperatures of 1100–1150°C under a stream of oxygen and is trapped in a receiver cooled with liquid nitrogen. The condensed SeO₂ is dissolved with a definite volume of diluted HNO₃ in the presence of Ni-nitrate and determined with high sensitivity and reliability by FAAS (electrodeless discharge lamp). The detection limit of the FAAS was found to be 3 · 10^–11 g of Se. The multi-stage procedure allows to detect Se levels 0.05 ppb in Ag and Au, 0.1 ppb in Cu, 0.2 ppb in Bi, and 10 ppb in Pb, respectively, with sample weights 10 g. For wire, rod, and chip samples the coefficients of variation are found to be between 3 and 6% for Se contents of 2 to 0.002 ppm. The quantitative evaporation of Se from Cu, Ag, Au, and Bi as well as the accuracy of the whole procedure have been checked systematically.

Die Arbeit wurde durch Mittel der DFG in dankenswerter Weise unterstützt.     

Study of Factors Affecting the Performance of Voltammetric Copper Sensors Based on Gly‐Gly‐His Modified Glassy Carbon and Gold Electrodes

This paper reports a study of the factors affecting the analytical performance of gold and glassy carbon electrodes modified with the tripeptide Gly‐Gly‐His for the detection of copper ions. Gly‐Gly‐His is attached to a glassy carbon (GC) surface modified with 4‐carboxyphenyl moieties or a gold surface modified with 3‐mercaptopropionic acid by the reaction of the N‐terminal amine group of the peptide with the carboxylic acid groups of the monolayer via carbodiimide activation. X‐ray photoelectron spectroscopy was used to characterize the steps in the biosensor fabrication. It was found that the analytical performance of a sensor prepared with Gly‐Gly‐His on a GC electrode was similar to that on a gold electrode under the same conditions. The performance was greatly enhanced at higher temperature, no added salt during copper accumulation and longer accumulation time within a pH range of 7–9. Interference studies and investigations of stability of the Gly‐Gly‐His sensor are reported. Analysis of natural water samples show that the sensors measure only copper ions that can complex at the sensor surface. Strongly complexed copper in natural water is not measured. Despite greater stability of diazonium salt derived monolayers on carbon surfaces compared with alkanethiols self‐assembled monolayers on gold, the stability of the sensors was essentially the same regardless of the modification procedure.     

Gold nanoparticles as dehydrogenase mimicking nanozymes for estradiol degradation

Small gold nanoparticles can mimic dehydrogenase activity to catalyze estradiol (E2) oxidation to estrone (E1), extending the range of nanozyme catalysis to environmentally and biologically important substrates.